|
SECTION 15: LADDER AND DIVING BOARD INSTALLATION
THE ANCHOR SOCKETS MUST BE LOCKED IN PLACE ON THE DECK END OF THE
LADDER. MASK THE LADDER ABOVE THE ANCHOR SOCKETS TO PREVENT GETTING
CONCRETE ON THE LADDER. LOCATE THE LADDER IN THE DESIRED LOCATION. ALIGN
AND PLUMB TO THE PROPER ELEVATION. TIE THE ANCHOR SOCKETS TO A STAKE OR
REE-BAR TO HOLD IN PLACE. RECHECK AFTER. POURING THE CONCRETE.
IF NO DECK IS BEING POURED AT PRESENT, THE LADDERS MAY BE ATTACHED
USING THE OPTIONAL ANCHOR KIT. SEE SECTION 20.
A DIVING BOARD SHOULD BE INSTALLED IN ACCORDANCE WITH THE
MANUFACTURER'S INSTRUCTIONS SUPPLIED WITH THE BOARD. THESE WILL VARY DUE
TO THE TYPE OF FULCRUM USED. SEE FIGURE 25 SHOWING BOARD PLACEMENT.
|
