|
SECTION 16: OPTIONAL POOL HEATER
HEATERS FOR POOL USE ARE MADE TO OPERATE ON NATURAL OR "BOTTLED" GAS
OR OIL FIRED. SOME ELECTRIC MODELS ARE AVAILABLE IN CERTAIN AREAS. THE SIZE
OF THE HEATER MUST BE SELECTED TO HANDLE THE CAPACITY OF YOUR POOL IN THE
TEMPERATURE REGION YOU ARE IN. YOUR DEALER HAS CHARTS THAT WILL GIVE THIS
INFORMATION.
THE HEATER MUST BE INSTALLED IN ACCORDANCE WITH ALL LOCAL AND STATE
CODES AND ACCORDING TO THE INSTRUCTIONS SUPPLIED WITH THE UNIT. THE HEATER
SHOULD BE LOCATED ON A CONCRETE PAD NEXT TO THE FILTER,
THE POOL HEATER SHOULD BE IN A WELL VENTILATED AREA BECAUSE THEY NEED
A FRESH AIR SUPPLY. THE HEATER SHOULD BE CONNECTED TO THE EFFLUENT SIDE OF
THE FILTER (DISCHARGE SIDE). THIS WILL ALLOW ONLY CLEAN WATER TO ENTER THE
HEATER. DIRTY WATER WOULD TEND TO RESTRICT THE HEATING CAPACITY OF YOUR
HEATER.
FOR COMPLETE PLUMBING AND ELECTRICAL REQUIREMENTS, REFER TO THE
BROCHURE SUPPLIED WITH EACH HEATER.
|
